![]() ![]() Open the Kontakt window (click Kontakt 4 or 5 in the step sequencer). At the top left you'll see FL Studio's options for the VST, along with a gear icon. Go ahead and click that, then Kontakt will disappear and FL greets you with wrapper settings. This will take Kontakt's separate insert outputs and send them to FL's mixer tracks. The first Kontakt insert goes to the mixer track that Kontakt is on, the second insert will always go to the one next to it. ![]() Alternatively, you can set the numbers yourself, but remember the numbers are relative position to the track Kontakt is on. Whatever output you put for “3” will go three mixer tracks to the right of the Kontakt mixer track. If you move the one 3 to the right, Kontakt will ignore that and still send it to whatever mixer track is 3 to the right of itself. So moving the mixer tracks in FL's mixer will not change what number FL mixer track Kontakt instruments go to. This is the most annoying part if you don't understand. Go ahead and hit the “Outputs” button at the top of Kontakt (IN the Kontakt window, pull it up by clicking the Kontakt channel in the step sequencer) Take a deep breath, maybe get a snack because this'll take some intense direction following. Punch in 8 or however many mixer tracks you think you need for the quantity and, of course, 2 for number of channels. 1 or whatever the first thing on the list is. ![]() Check Ascending Output Assignment.Ĭheck both of the next check boxes and hit OK. If there's anything else there besides the four aux. Go to add channels, then punch in whatever number you want. Where it says “Soundcard/Host Output”, select whatever the third option is and make sure “Ascending Output Assignment” is selected. Go ahead and check “make this your default configuration”. Now if you did that right, you'll see 8 (or whatever #) Kontakt inserts (st. 1, you'll see “1|2” If they go up sequentially already so that st. Move on to the last paragraph in this section if you're done. If not.Ĭlick on the first one of those blank ones you see. Click on the “Not Connected” (there should be two, left and right) and you'll get a little dropdown menu. Select the second pair of channels, whatever they are named. Then for the third Kontakt insert, select the third pair of channels. You should be seeing “3|4” and “5|6” respectfully. When you're done, go to the dropdown menu at the top between “Outputs” and “Add Channels”. Save the current state as default for all formats. Now you'll never have to go through this nightmare again. #Kontakt 5 player midi keyboard install. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |